Sauder 414720 Instruction Manual download pdf (Page 2)

Table of Contents Assembly Tools Required

5-22

23-25

26-28

29-30

Part Identiﬁ cation

Hardware Identiﬁ cation

Assembly Steps

Français

Español

Safety

Warranty

Hammer

Not actual size

No. 2 Phillips Screwdriver

Tip Shown Actual Size

Use of a TV that is too heavy or large is hazardous. A TV that is too heavy will create a risk of a tip-over that can cause severe injury or

death. A TV that is too large for the available space might be accidentally pushed or bumped o the furniture, or subject to tip-over.

• Check the size and weight of your TV. Compare it to the diagram below – before you begin assembly!

• This Sauder unit is designed for use with televisions weighing less than 50 pounds. Never use with a TV that weighs more.

• The size of the television, front-to-back and side-to-side, must ﬁ t within the space deﬁ ned in the diagram.

• Never place the front edge of the TV past the front edge of the TV support shelf (or stop molding – if equipped)

• Never allow the sides of the TV to extend past the side edges of the TV support surface.

• If the TV has a CRT picture tube, the picture tube cone may extend past the rear of the support shelf.

• Be sure to apply the warning label as instructed in the last assembly step. The label provides important safety related information.

WARNING

50 lbs.

18-3/4"

41-5/8"

Skip the power trip.

This time.

414720 www.sauder.com/servicesPage 2

1 2 3 4 5 6 7 ... 31 32

No comments

Sauder 414720 Instruction Manual Page 2